Name: ROWEN TRUNK SPOILER TYPE II For NISSAN GTR R35 2007~2022
Availability: InStock

Description

The genuine high-mount stop lamp is to be reused.

Warnings:
- - Perform a dry fit to adjust balance before final installation; minor modifications may be required.
  - No returns are accepted after painting or vehicle installation.
  - Avoid dropping or applying excessive force, as improper installation can cause detachment, breakage, accidents, or failures while driving.
  - Use a hairdryer to warm the mounting surface if ambient temperatures are low, and allow double-sided tape to cure for 24 hours without exposure to water.

Components:
- - Rear Wing: Rear wing body (× 1), center stay (× 1), flange bolts M6 × 16 (× 6), washers M6 (× 6), double-sided tape (30cm) (× 1).
  - Trunk Spoiler: Trunk spoiler body (× 1), double-sided tape (3.0m, 1.2mm thick, 10mm wide) (× 1).

🛠️ General Installation Requirements

- Surface Prep: Completely remove all dirt, oil, and grease from the installation surfaces. If installing in winter or cold temperatures, warm up the mounting surface with a hair dryer before adhering.
- Curing Time: Avoid washing the vehicle or exposing it to rain or water for 24 hours after applying the double-sided tape.
- Sealing: It is recommended to use caulking bond (sold separately) to seal any gaps between the product and the vehicle body.

🏎️ Rear Wing Installation Procedure

1. Remove the factory rear wing according to the vehicle’s service manual. Disconnect the high-mount stop lamp main body and its wiring harness from the factory wing.
2. Reinstall the removed high-mount stop lamp main body and harness into the new aftermarket rear wing.
3. Affix the included double-sided tape to the bottom of the included Center Stay. Secure the Center Stay to the rear wing body using the included M6 x 25 bolts.
4. Peel back a small section of the double-sided tape backing on the Center Stay and fold it outward. Temporarily place the assembly onto the vehicle to adjust the balance. Secure the main body using the included M6 x 16 bolts paired with M6 washers.
5. Check and confirm the tightness and fitment of all components.

🚗 Trunk Spoiler Installation Procedure

Affix the included double-sided tape to the mounting surface of the trunk spoiler body.
Peel back a small portion of the double-sided tape backing. Temporarily place the spoiler on the vehicle to adjust the overall alignment and balance. Once aligned, peel the remaining backing off completely and press down firmly to adhere.
Check and confirm the final fitment and tightness of all components.