Description

Steering Switch Case Pro-19S
This kit allows you to transfer the function switches from your factory steering wheel directly into a dedicated switch case when upgrading to an aftermarket steering wheel.
We developed this version for the GR Yaris (early model) by leveraging our design expertise from previous vehicle models.
We optimized the switch layout by incorporating rocker-style paddle switches for some of the functions.
This design enables compatibility with a wide range of aftermarket steering wheels.
The “Pro” model features a new backlight function not found in previous versions. This significantly improves switch visibility in dark environments or during night driving, ensuring safer and more comfortable operation.

【Compatible Model Years】
GR Yaris
Compatible with “early model” vehicles delivered between April 2021 and approximately March 2024.

【Transmission】
Please select your paddle lever preference from the options at the bottom of the purchase page based on your transmission type.
Select “None” for Manual Transmission (MT) models. For CVT models, select either carbon or aluminum paddle levers.
Please be sure to make a selection.
You may select “None” for CVT models, but please note that shifting gears via paddle levers will not be possible.
If you select “None,” paddle levers can be purchased separately later, though additional installation work will be required.

【Delivery Time】
Currently available for shipment within 5 weeks.

[Options ]

Paddle unit (Carbon) 

Paddle unit (Aluminium)

【Materials】
Front: Dry carbon | Back: ABS

【Confirmed Compatible Steering Wheels】
-Confirmed as of December 1, 2022. We will update this list as new models are confirmed.

momo JET 32
momo M08
OMP WRC
OMP Targa 33
OMP VOLANTE 320*
*Requires a separate 5mm spacer.

【Note】A separate steering wheel boss kit is required for installation.

【About Boss Kits and Rapfix II】
The Steering Switch Case (hereinafter SSC) is compatible with Works Bell boss kits and the Rapfix II.
The installation order is as follows: ■ Installation Order
Pattern 1
Vehicle Body → Boss → SSC → SW
Pattern 2
Vehicle Body → Short Boss → RAPFIX II → SSC → SW
Pattern 3
Vehicle Body → Short Boss → SSC → RAPFIX II → SW

• SSC (Steering Switch Case)
• SW (Steering Wheel)
• Pattern 2 requires a 13-pin insulator/flipper.
• Pattern 3 requires a 15mm spacer between the short boss and the SSC.

【About the 13-pin Insulator】
When securing the setup using RAPFIX II, this product is installed between the steering wheel and the RAPFIX unit (see Pattern 2 above).

In this case, a pre-wired 13-pin insulator is required.
Standard Works Bell 13-pin insulators are not pre-wired. We sell pre-wired 13-pin insulators, so please feel free to contact us.

【About GTC】
When installing with the Works Bell RAPFIX GTC, installation is not possible unless the wiring connecting the SSC and the roll connector is routed outside the unit.
If you select GTC when ordering, the necessary additional parts will be included:
Dedicated cord (extension cord) … ¥4,000
15mm spacer … ¥2,900

【Installation with MOMO Steering Wheels】
When installing a MOMO-compatible horn button, you may need to modify the horn ring included with the RAPFIX II by grinding it down to allow the wiring to pass through.
Please exercise caution during assembly to avoid damaging the steering switch case wiring.